Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
1 - 9 of 9 Posts

·
Registered
Joined
·
937 Posts
Discussion Starter · #1 ·
I know it's because of the vacuum pump, but c'mon! The only light bar available for the '12-'13 stock bumper is the RealWheels Pre-runner, and that thing is just weak sauce... Anybody know if any of these companies have a bar in the works???
 

·
Registered
Joined
·
4,718 Posts
What are you looking for? I have a rugged ridge light bar on my stock bumper and its fine to me can hold three 6" lights and bolts to factory mounts I don't understand what you mean by no light bars when there are at least two I see daily on this forum
 

·
Registered
Joined
·
937 Posts
Discussion Starter · #3 ·
Farnham21 said:
What are you looking for? I have a rugged ridge light bar on my stock bumper and its fine to me can hold three 6" lights and bolts to factory mounts I don't understand what you mean by no light bars when there are at least two I see daily on this forum
The RR bar is too small... I want the one by Off Camber that goes on '07-'11 JK's--3" thick tubing, comes up higher, looks like a pseudo-stinger... I'm not gonna put lights on the bar... I already have KC's on the windshield... I just want the bar itself, a manly bar.
 

·
Registered
Joined
·
937 Posts
Discussion Starter · #5 ·
Farnham21 said:
That one should work they didn't change the bumper after 2011 websites are just too lazy to change it
It's not the bumper that changed...The bar doesn't work because of the new motor--the vacuum pump is in the way, so a new bracket is needed...
 

·
Registered
Joined
·
92 Posts
I was in the same situation as you. I ended up emailing MBRP and you can order their relocating evap mount so you can use the their bullbar/light bar. I don't have the part # near me but as others have said there are multiple companies who have relocating brackets or mounts available.
 
1 - 9 of 9 Posts
Top