Jeep Wrangler Forum banner
1 - 2 of 2 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
Hey guys, new to the forum... here goes, installed an aftermarket radio and subwoofer last weekend. Blew a couple fuses, replaced them and radio/sub worked fine. Didnt try driving it until the next morning, started right up, went into gear, pushed gas pedal and... NOTHING. The Electronic Throttle Control light (red lightening bold) is on between the speedometer and tachometer. Ive disconnected the battery, checked fuses, disconnected the new radio/sub, hooked everything back up like it was factory and nothing has changed. Called dealer and they think a bus line? has been interfered with and possibly blew a module.. Any tricks I should try before I load it up and take it to town?

Thanks for the help
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.