[dlee]

When I purchased this 2000 Jeep TJ, I noticed the rear brake lines are not fasten to anything, it has a 4 inch lift pro comp lift on it. Does anyone have a picture I could look at, so I know how this should go? I would have thought the lift kit would come with some type of relocation bracket of some sort

Thx

 

[Holton345]

Here is another pic request. Post a pic to show exactly what it is that you are asking about.

 

[dlee]

Picture

As you can see in the picture, this is zip tied to my upper control arm

 

[dlee]

This might be a better picture

 

[Water Dog]

That's what most do...zip tie it to the upper control arm.

 

[Ryan Angela]

That's what most do...zip tie it to the upper control arm.

X2. The factory control arm has a spot for the brake line support bracket to bolt to. The aftermarket arms don't have this spot. On two lifts I've done, I've removed the support bracket from the line to avoid any clunking, and ziptied the line to the upper control arm.

 

[UnlimitedLJ04]

I used stainless adel clamps & stainless bolts. Works great.

 

[Laggy]

Loose zip ties work fine. Or stainless clamps. Regardless make sure there's plenty of room for movement, and no sharp edges.

I also used spiral wire wrap for extra abrasion protection

 

[dlee]

Thanks everyone for the replies...zip ties it is!

 

[Laggy]

Zip Tying Wizard: Level 99