Jeep Wrangler Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
163 Posts
Discussion Starter · #1 ·
So I recently regeared and am working on using my old D30 pinion gear as a shift knob (from a 3.73 set). Trouble is, it's quite heavy even after being cut down and drilled out. Anyone know if the weight will cause any issue in the transmission? I have the NV3550. Thanks ahead of time.
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top