Jeep Wrangler Forum banner

Power Lock Problem & Window Switch

1034 Views 3 Replies 2 Participants Last post by  G-Pur
I don't know if this is just coincidence, but it's odd timing. I have an '07 JKU X and within the last two weeks my driver's door lock has intermittently stopped working with the internal switch and the fob. It'll still work manually, but after two years of ownership and having the convenience of remote door lock, I keep forgetting to push the lock switch.

I've never taken the doors off, so I doubt that the connection loosened at all.

The other issue I'm having is that the little led in the driver's door power window switch on the center stack has gone out. Usually it's not an issue unless I'm trying to put the window down at night. Then it results in a bunch of awkward fumbling around in the dark trying to find the right spot. Kind of like dating in high school.

Anyone have thoughts on either or both issues?
1 - 4 of 4 Posts

· Registered
Joined
·
10,336 Posts
I've never taken the doors off, so I doubt that the connection loosened at all.
Based on what?

Even if you never intentionally disconnected it, that's the first place I would look for a loose connection based on the Wrangler design.
 

· Registered
Joined
·
10,336 Posts
The other issue I'm having is that the little led in the driver's door power window switch on the center stack has gone out. Usually it's not an issue unless I'm trying to put the window down at night. Then it results in a bunch of awkward fumbling around in the dark trying to find the right spot. Kind of like dating in high school.
Are the other three LED's still working?
 

· Registered
Joined
·
1,146 Posts
Discussion Starter · #4 ·
Well, the window still works, so I'm assuming that the connection is ok, but I will check it anyways.

And yes, every other light on the dash and stack work just fine.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top