Jeep Wrangler Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
279 Posts
Discussion Starter #1
Hey guys, I've been pricing out my build to run 37s and I've opted to not dump money into my dana 30. I've been able to make room in my budget to be able to get a full prorock assembled by northridge but it wouldn't leave any room in my budget to reinforce it at all. Would you guys trust 37s on just a prorock 44 alone?
 

·
Registered
Joined
·
331 Posts
No need for the ProRock 44 bigger and stronger axle housing plus stronger C's also you have a choice when ordering between 5/16" and 1/2" axle tubes.
 

·
Registered
Joined
·
3,428 Posts
Yeah, the aftermarket axles are much beefier than the Rubi D44. That Rubi axle is basically a D30 with a D44 center section. The aftermarket axles have the D44 center section with full strength D44 tubes and "C"s.
 

·
Registered
Joined
·
279 Posts
Discussion Starter #7
Yeah, the aftermarket axles are much beefier than the Rubi D44. That Rubi axle is basically a D30 with a D44 center section. The aftermarket axles have the D44 center section with full strength D44 tubes and "C"s.
Awesome, thanks everyone! You just saved me a whole lot of headaches.
 
1 - 7 of 7 Posts
Top