[Yellow_Fox]

hey everyone i need help with my daystar switches i have them installed and everything and the work but is the led light always supposed to be on? i thought it was supposed to only be on when the light was on. any help would be greatly appreciated. I have two switches one goes to two kc lights mounted by the windshield the other switch goes to two mounted on the front bumper. Both switches always have the led light on. Thnx for help in advance

 

[Yellow_Fox]

sparky im not a hundred percent what yu mean but i think theres 3 wires going to the switch. the ground which is brown a white one and a green one if thats what you mean

 

[Yellow_Fox]

when i disconnect the ground wire though the fuses like to break. and both the green and white wire go connected to the positive terminal on the battery correct?

 

[Yellow_Fox]

i will take i pic of how i have it set up an post it. It will probably be a lil later tho

 

[Yellow_Fox]

im not much of an electrician haha =p

 

[Yellow_Fox]

lighting

heres how i have the wires set up to my battery if it helps. i kno the ground is the brown one how about the white and the green which ones are which

 

[Yellow_Fox]

my lights have a relay on them already and ill check it out today

 

[Yellow_Fox]

yea i explained the set up i have running to the battery wrong. I have the white wire connected to the battery and a yellow wire. The white wire goes directly to the switch and the yellow wire goes to the relay. The green wire goes from the relay to the switch. Now as for the led light always being on i fixed that by switching the position of the white and the green wire from the back of the switch. Thanx you guys and for anyone who always wants that little led light on just switch the positioning of the green and white wires going into the back of the switch