Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
1 - 5 of 5 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
Are the u joints for the rear driveshaft different sizes? I just measured them on the jeep and one looked like 3 5/8 and the one by transfer case looked like 3 3/8.
 

·
Registered
Joined
·
50 Posts
If you have the HO 4.o, they are, sometimes! Depends on where and when it was built.

I just went thru that with nmy '89 4.2 Mine should both be the shorter ones, but Auto Zone sold me two of the longer ones.

Didn't notice unti I had the damn thing pressed in!
 

·
Registered
Joined
·
121 Posts
Yep. My 94 is that way, and it's only a 4 banger and a 5 spd. 1310 in the front and 1330 in the rear.
 

·
Administrator
Joined
·
12,630 Posts

·
Registered
Joined
·
4,917 Posts
Same with my 94 4.0, 1330 at the rear chunk. Lost a tab and had to put in a new pinion yoke, now it's a 1330 to 1330S. Imagine if I was your P.O.! :rofl:
 
1 - 5 of 5 Posts
Top