Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of JUNE's Ride of the Month Challenge!

1 - 4 of 4 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
So today I tried to put on my rear track bar relocation bracket to go along with my rough country 2.5" lift. In the directions it said you only have to remove the bolt on the axle side of the track bar. After doing that I couldn't get the track bar out of the bracket. I tried to remove the bolt on the other side but it was extremely rusty and I couldn't get it out. Is there any way to get the track bar out of the original bracket without removing the whole trackbar so that I can install the relocation bracket? Any help would be apreciated. Thanks
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #3 ·
It was only like half way out. Do you think that's far enough out to pry it. I tried using a racket strap to pull the axle over but that only made it move a little
 

·
Registered
Joined
·
541 Posts
BFH. Also bomb the other bolt with PB Blaser. My advice is replace both bushings while you have it out. The bushing could be toast, mushrooming out, which will make it super tight.
 
1 - 4 of 4 Posts
Top