Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of JUNE's Ride of the Month Challenge!

1 - 1 of 1 Posts

·
Premium Member
Joined
·
368 Posts
Discussion Starter · #1 ·
Looking on many sites, can't seem to nail down an answer.

I bought the in dash switch setup from 12 volt guy, have it in the dash, but can't seem to figure out the wiring to the solenoid. The winch was purchased around Christmas.

View attachment 1137833

I tested out and found what I believe are the in and out points, and wired the new harness (green in, red out, brown ground) from 12voltguy as instructed.

View attachment 1137841

So, why won't it work? What am I missing?
 
1 - 1 of 1 Posts
Top