Jeep Wrangler Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hey y’all new to the forum just trying to get some ideas of how to go about this, recently I went backroading and slid over an embankment and my passenger tail light hit a tree and dented in the cab corner. The dent is not that big and I plan on putting on Smittybilt XRC Rear Corner Guards to cover this up but I would like to pop the dent out as much as I can and realign my tail light. Any ideas on how to go about it? Thanks!
 

Attachments

·
Registered
Joined
·
962 Posts
Remove the two screws from the taillight, take it off the corner, and try to pull it back out? I can't tell how bad the dent is

Sent from my SM-T380 using Tapatalk
 
1 - 4 of 4 Posts
Top