Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of JUNE's Ride of the Month Challenge!

1 - 2 of 2 Posts

·
Premium Member
Joined
·
822 Posts
Discussion Starter · #1 ·
The power cables to my Engo winch are sowing some wear now where they connect to the winch. The small "boots" are degraded from the sun and elements. The winch is still working fine, but I'd like to replace the cables.

Can someone point me in the right direction as to size and vendor?

I also need to figure out a way to repair/secure the control connection port. The plastic housing is loose.

It's an Engo 10S that was bought either late 2014 or early 2015 can't remember.

Any suggestions or recommendations?
 

·
Registered
Joined
·
2,409 Posts
Did you call engo?
 
1 - 2 of 2 Posts
Top