Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
1 - 4 of 4 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
I am in the process of purchasing some Rocker panel plates. I have a bit of rust starting, where they would cover. I thought about sanding down and putting some primer before installing the rocker panel plates, what have you people done to stop the rust in that area? thanks
 

·
Registered
Joined
·
1,249 Posts
That would be a good idea. Definitely get the rust off of there before installing your rocker guards, or you'll just end up with a rusty body AND rusty rocker guards.

I would sand and prime it and then use a liner under the rocker guards to keep moisture out.
 

·
Registered
Joined
·
256 Posts
ive got some really bad rust on my drivers side, and am havin a guy at work cut it out and weld in a new piece, them im goin to get the rocker guards, otherwise if water gets back there somehow or another its just goin to sit on the rust and make it get worse
 
1 - 4 of 4 Posts
Top