[donald]

i have a 1990 YJ and the driver side foor pan is totally shot and i think im going to have to replace the the floor under the seat also so where can a man buy the replacement floor pan for under the seat at

 

[yj_1988]

https://www.quadratec.com/products/22507_01_07.htm

 

[yj_1988]

My bad, that's the floor pan. I was looking through my new Essentials and they don't have that area for the YJ. My guess is that it is the same dimension wise as a CJ, not sure though. They only list the CJ-7 for many of the replacement sheet metal parts. I'm ordering two floor pans for my dad's first of two recently purchased Scramblers and know that those pans are the same as the CJ-7 and are not listed as CJ-8.

 

[4Jeepn]

not sure how good they are but:

http://www.jcwhitney.com/autoparts/Product/Pr-p_Product.CATENTRY_ID:2000442/c-10101/Nty-1/p-2000442/Ntx-mode+matchallpartial/N-10101/tf-Browse/s-10101/Ntk-AllTextSearchGroup?Ntt=jeep+floor+pan

 

[socalchef]

dunno how bad shipping would be but ic an get what you need from a friends jeep junk yard here in so cal

 

[R.P.M.]

Our 93 YJ had a hole the size of a basketball in the floor as well as a hole in the rockerpannel. Ordered em up from JC Whitney and got em right away, but then we are in Michigan. Now the L shaped rocker replacement goes from below the cowl to about half way back (under the door) AND it does NOT have JEEP stamped into it. Had the body work done by a bodyshop manager who moonlights at home for half the cost. His only comment was that they were oversized and that he had to trim to fit. But I guess that is better than being to small. These are the only body panels that we have gotten from JC Whitney (so far)