Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of JUNE's Ride of the Month Challenge!

1 - 2 of 2 Posts

·
Registered
Joined
·
296 Posts
Discussion Starter · #1 ·
I have 31 inch 10.5 wheels. I would like to replace the stock TJ Fender Flares with something that sits more flush to the body. Does anybody make something like that without any cutting? I see the tube flare kits but I don't think I want to go that route.
 

·
Registered
Joined
·
1,321 Posts
I'm not aware of any that are narrower than stock. Have you considered just trimming yours down? Worst case scenario is if you don't end up liking it the stock ones are easily and cheaply replaced with used ones, of which there are many taken off of other Jeeps.
 
1 - 2 of 2 Posts
Top