Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of Aug's Ride of the Month Challenge!
1 - 4 of 4 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
I just finished up installing the JKS 1.25" BL that came with Dirk's Ultimate kit last night. I followed the instructions to a t and ended up torquing the bolts to 31 ft-lbs. The instructions called for 30-35. After doing so I noticed there is a slight compression or bulge to the spacers. Is this normal? It's not so much that I'm all that concerned. Just wondering if I should back them off a little.

Thanks, guys and or ladies!
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top