Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of JUNE's Ride of the Month Challenge!

1 - 3 of 3 Posts

·
Registered
Joined
·
133 Posts
Discussion Starter · #1 ·
I am thinking about making a few things to help me past the time while I wait in purgatory for my Jeep to be built but I need some measurements from the back of the jeep.
I believe the role bar is about 7” in diameter (9 ½ with the foam)?
I want to know the usable space in the bed in back so the floor space from wheel well to wheel well and then from tail gate to back of rear seats. I am going to build a tank rack for that area.
I am also wondering the inside measurements of the triangle-shaped area of the role bars (flying buttresses) and the inside length and width of the sloped area going down to the tail gate. I’ve made fishing nets before so I think I could probably make a cargo net back there.
Thanks
 

·
Registered
Joined
·
2,866 Posts
The roll bar isn't any where close to being 7" in diameter. That would be enormous. It is more like 2" or 3" diameter. I'm not sure about the other dimensions.
 
1 - 3 of 3 Posts
Top