Jeep Wrangler Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
4,757 Posts
I would say that its in the circuit board on the back side of the speedo. Maybe do a continuity test on the wiring harness from the t-case to the dash.

The circuit board is a very sensitive, POS, that was a bad idea from day one. And expensive to replace as well. If the light doesnt work either, and you have deciphered that it isnt just a bad bulb, then perhaps it might be a bad ground to the circuit board.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top