Jeep Wrangler Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
127 Posts
Discussion Starter · #1 ·
The PO had stuck screws in the hazard switch and turn signal lever. That meant no wipers. I have had the steering wheel off before, but was not ready to work on the other stuff. Simple stuff taking a steering wheel off and putting one back on.

I have tried now, 3x to get the wheel of, using two different pullers. One just bends the bolts when you wrench down on it. At this point, I am no sure it wouldnt be easier to just go get an s10 steering column from a junk yard.

Ever had a steering wheel refuse to budge? What could the problem be?
 

· Registered
Joined
·
127 Posts
Discussion Starter · #3 ·
I have had the wheel off before! Simple stuff. This time, it will not budge. Never seen anything like it. I trashed the steerning column trying, I think. now has a slight grinding feel when turning the wheel. Oh well. The other one will be here today.
 

· Registered
Joined
·
127 Posts
Discussion Starter · #5 ·
Goatman, i did that, repeatedly. I tried rocking it, popping towards dash, away from dash, pb blaster, etc. i treid heat on the wheel. I picked up a used one today. I am just going to swap them.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top