Jeep Wrangler Forum banner

Stuck Steering wheel

1233 Views 4 Replies 3 Participants Last post by  Bill_FL
The PO had stuck screws in the hazard switch and turn signal lever. That meant no wipers. I have had the steering wheel off before, but was not ready to work on the other stuff. Simple stuff taking a steering wheel off and putting one back on.

I have tried now, 3x to get the wheel of, using two different pullers. One just bends the bolts when you wrench down on it. At this point, I am no sure it wouldnt be easier to just go get an s10 steering column from a junk yard.

Ever had a steering wheel refuse to budge? What could the problem be?
1 - 1 of 1 Posts

· Registered
Joined
·
259 Posts
Put the puller on it and tighten it up then pop it with a sharp smack from a hammer. The jolt should make it pop off.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top