Jeep Wrangler Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
59 Posts
Discussion Starter #1
Hi,

About to install a load resistor for a new led light upgrade, however it would come in handy to know the color codes used for the 2013 jk.

So far, black obviously is the ground, however what is the "Running light" and the "stop turn lights" colors?.

Here is a diagram of the colors, any help would be appreciated ... otherwise have to remove the butt connectors... use a multimeter... yeah not my idea of fun ;).



Thanks!

Bob
 

·
Registered
Joined
·
59 Posts
Discussion Starter #2
Hi,

About to install a load resistor for a new led light upgrade, however it would come in handy to know the color codes used for the 2013 jk.

So far, black obviously is the ground, however what is the "Running light" and the "stop turn lights" colors?.

Here is a diagram of the colors, any help would be appreciated ... otherwise have to remove the butt connectors... use a multimeter... yeah not my idea of fun ;).



Thanks!

Bob
Just got my answer :

White with a yellow stripe = Brake/Turn
White with a purple stripe = Running
White with a green stripe = Back up lights
 

·
Registered
Joined
·
124 Posts
Just got my answer :

White with a yellow stripe = Brake/Turn
White with a purple stripe = Running
White with a green stripe = Back up lights

Did you run the resistor into the yellow/white brake/turn?

I'm almost full LEDs with proper signaling pace and resistors, minutes away from installing my resistors that showed up this AM!
 

·
Registered
Joined
·
96 Posts
Hey im new to the forum. Im tyler. Just thought i would check out these posts.
 

·
Registered
Joined
·
93 Posts
Added LED bulbs to the tail lights. Hooked the resistor up to the white/yellow turn signal wire and ground. Still not functioning properly. It is the 50w 6ohm resistor as indicated is the correct one, but no dice. What am I missing here?
 
1 - 8 of 8 Posts
Top