Jeep Wrangler Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
131 Posts
Discussion Starter #1
Hey guys need a little advise. I'm getting ready to remove my rear lower flex arms to replace the bushings that are worn out. I don't have them off yet, so I'm wondering how they actually adjust for length? I probably won't need to make an adjustment but cannot figure out just by looking at them how they adjust. They look like they are two tubes that slide together. I searched the Tera flex site but cannot find anything. This is a 4 inch lift put on in 2005 on my 03 TJ rubicon. Thanks to all. Really appreciate advice.
 

·
Knows a couple things...
Joined
·
49,115 Posts
If it's the Tera arms I am thinking of, their length is adjusted by simply screwing them into or out of each other.
 

·
Registered
Joined
·
131 Posts
Discussion Starter #3
Thanks Jerry, you were right...they simply screw together. Replaced the bushings and it feels like a new jeep. Unbelievable difference. Thanks
 
1 - 3 of 3 Posts
Top