Jeep Wrangler Forum banner
1 - 1 of 6 Posts

· Registered
2,424 Posts
Not necessary. I wouldn't even call it advisable. The axle will shift sideways when you install the lift but not enough to affect alignment or anything. I couldn't even tell on mine until I measured it. The stock bar is adequate for most situations but a new TB isn't going to hurt.

DealerJoe's advice is good. If you decided to get one, get a good adjustable bar. Teraflex's Monster Tb gets a lot of good reviews and it's plenty strong. The bolt is a good advise too. In fact, changing out all the TB and lower control arm bolts is a good idea. Keeping them properly torqued is too.
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.