Jeep Wrangler Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
165 Posts
Discussion Starter #1
so today i got in the jeep at lunch and started to drive and felt wierd. i pushed the clutch in and it was making a grinding noise. cant figure out why, so while i'm driving it's doing this. never done it before but dont know when the last time the clutch was replaced... its an ax10 i believe, 5speed on a 2.5. any ideas on what it may be?
 

·
Registered
Joined
·
1,056 Posts
Does it do it at a stand still as well?
Or only when your moving?
In gear out of gear?

Try to give the people here the exact moment when it happens and when it doesn't.
 

·
Registered
Joined
·
165 Posts
Discussion Starter #4
it does it out of gear at a sit and while moving. makes the jeep a little hesitant to go into gear also.....
 

·
Registered
Joined
·
704 Posts
Only when you push the clutch in?
 

·
Registered
Joined
·
165 Posts
Discussion Starter #6
only when i push my clutch in. it sounds as if my 4wd isnt disengaging all the way like its grinding gears.
 

·
Registered
Joined
·
704 Posts
I'm guessing throw out bearing....but you better wait for more experienced opinions.
 

·
Administrator
Joined
·
12,609 Posts
How is the clutch fluid level?
 

·
Registered
Joined
·
165 Posts
Discussion Starter #10
it does this in neutral when i let the clutch out also, the clutch fluid is full. now i used to have a leak in the trans, so i wounder if the fluid level is low.... how do i check this?
 
1 - 10 of 10 Posts
Top