Jeep Wrangler Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1
Had a bad shake and went to get it aligned again then they told me my rear axle is off, new to the Jeepin community and was wondering if anyone knew how I could set it back to where it's supposed to be. I'd rather do the work myself cause well I'm a college student and it seems like everyone wants an arm and a leg to work on a wrangler around here. Any help would be greatly appreciated.
 

·
Registered
Joined
·
14 Posts
Discussion Starter #3
front to back the left is a little bit more forward than the right side of the axle putting a strain on the drive shaft
 

·
Registered
Joined
·
6,013 Posts
Do you have adjustable control arms?
 

·
Registered
Joined
·
14 Posts
Discussion Starter #5
no if i order a pair will that do the trick it's less than an inch that its off its -.19 on one side and .26 on the other
 

·
Registered
Joined
·
908 Posts
That's a bad bushing or a bent arm . And if they are trying to give you a four wheel alignment they are ripping you off Nothing moves on the back of the Jeep Unless you have adjustable control arms . You have four total in the rear Two uppers and two lowers
 

·
Registered
Joined
·
14 Posts
Discussion Starter #7
k appreciate it i'll probably just buy adjustables when I do my next lift cause I'm not really liking the zone lift and want something with the bent arms to have a little more flex
 
1 - 7 of 7 Posts
Top