Jeep Wrangler Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
106 Posts
Discussion Starter #1
Does anyone know what the u bolts are supposed to be torqued to? I have a 95 Wrangler but did a rear axle swap to a Chrysler 825 if that matters for torquing it down.

:blunt:
 

·
Premium Member
Joined
·
1,015 Posts
Rastaman, I looked at 3 different manuals and none of them mentioned torque value for the u-bolts....sorry i'm no help.....i'll keep looking though.
 

·
Registered
Joined
·
106 Posts
Discussion Starter #3
Thanks man, I'm hitting the same wall. I had a problem and think the bolts may not have been tight enough and allowed the axle to spin thus blowing up my yoke and the shroud on m y transfer case. Not a fun weekend.
 

·
Registered
Joined
·
925 Posts
Thanks man, I'm hitting the same wall. I had a problem and think the bolts may not have been tight enough and allowed the axle to spin thus blowing up my yoke and the shroud on m y transfer case. Not a fun weekend.
oh snap that blows, how could that have happened?
 

·
Administrator
Joined
·
12,613 Posts
65 on RC install for YJ lift instructions.. which seems low.
 

·
Super Moderator
Joined
·
12,269 Posts
1 - 9 of 9 Posts
Top