Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of Aug's Ride of the Month Challenge!
1 - 1 of 1 Posts

920 Posts
Discussion Starter · #1 ·
Hey guys, same deal as the clutches... since i got the car apart now, im going to go ahead and replace the u-joints. I checked q-tec, and saw they come in 2 sizes, for the 3.5" yoke and 3.9" yoke. I measured my yokes last night, and found that the front drive shaft has the 3.5 while the rear, shorter one has the 3.9, so i would need 2 of each. can anyone tell me if this is correct?

oh, and i have a 94 yj, so i dont know if the driveshafts are model specific... i didnt think they were, but if they are, could a mod could move this to the yj section please.... thanks in advance guys

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.