Jeep Wrangler Forum banner
1 - 1 of 6 Posts

· Registered
33 Posts
just noticed you have all the parts just be sure to support the transmission when dropping the skid plate. I made the same mistake the first time I dropped a yj skid plate so don't feel too bad. I had to replace some of my parts as mine was missing the torque bracket and the transmission wasn't even bolt to the mount. I just put the rolling floor jack underneath it and then I had to use a ratchet strap attached to the drive shaft to persuade it over and realign everything. Then I tightened the hardware and was good to go.
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.