Jeep Wrangler Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
95 Posts
Discussion Starter #1
I just got a new Warn Zeon 10-S installed last August, now today I went to use it and couldn't get the motor to engage. The winch just free spools. The winch controls seem to make the motor work, and when winching out it looks like it's trying to turn. But if you pull on the cable it just runs out freely.

Are there any suggestions anyone has? This winch has only been used once and was working fine at that point (stuck on a snowy road this past fall).

Thanks
R
 

·
Registered
Joined
·
106 Posts
Cycle the selector a few times and if that doesn’t do it call warn, it’s under warranty.
 

·
Registered
Joined
·
2,974 Posts
Try a little light penatrating oil on the selector lever. Mine gets stuck if I don't use it all the time. Might have to cycle the drume too just a little to get those geard to engage.
 
1 - 4 of 4 Posts
Top