Jeep Wrangler Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
1 - 1 of 1 Posts

·
Registered
Joined
·
3,540 Posts
Discussion Starter · #1 ·
Lost track of previous "How much does it sag?" thread.

Installed 10,500 Rugged Ridge winch today with 100' synthetic rope.

Actual measured sag was 3/8" from mark prior to install.
Didn't have the sag measured before that when putting on the Warn Elete (they tell me "around 111 #"), so total load to front bumper is around '155#' as far as I can estimate.

Weigh scale pre winch was 2250 front/2400 rear with some just in there. I had been out to it before with OEM bumper still bolted on, and that was what I thought it was then too...although I do have it written down somewhere.

Actually took photo of readout this time though.

Will get back out to weigh tomorrow for those so interested.
 
1 - 1 of 1 Posts
Top