I've been slowly working on installing a hydro-assist kit on my TJ, after replacing the steering box. It's a PSC steering gearbox with PSC piston and Mr. Blaine's mounting kit.
Now that everything's installed, I'm not actually sure which side of the piston is supposed to go to which output on the steering gearbox. From a different forum someone mentioned the front output is the left turn port, and the rear is the right turn port. Is there documentation confirming this, or at least someone who's run the same SG400R steering gears?
Finally, there's a lot of play around the shaft end that connect to my tie rod, am I just supposed to torque the heck out of that bolt, bending the bracket and clamping down on it? Or should I find some bushings to install on each side, so it's nice an centered in the bracket?
Once the pictures I take on my phone make it to the cloud, I'll post them to help out.
Thanks for the help everyone!
Now that everything's installed, I'm not actually sure which side of the piston is supposed to go to which output on the steering gearbox. From a different forum someone mentioned the front output is the left turn port, and the rear is the right turn port. Is there documentation confirming this, or at least someone who's run the same SG400R steering gears?
Finally, there's a lot of play around the shaft end that connect to my tie rod, am I just supposed to torque the heck out of that bolt, bending the bracket and clamping down on it? Or should I find some bushings to install on each side, so it's nice an centered in the bracket?
Once the pictures I take on my phone make it to the cloud, I'll post them to help out.
Thanks for the help everyone!
