[moparmadness1973]

Interested to see what advice you receive. Have you done a crank-cam relearn and phaser clean? Do you have correct tyres size and gearing programmed into your pcm? How fresh is your oil and filter? Trans oil?

It is a 2014 stock wrangler.

 

[moparmadness1973]

Did you replace or reset a cam phaser, sensor, or crank sensor? Does the initial fault coincide with an oil change?

oil is fresh with a mopar filter. It threw a code for a thermostat replaced the neck and all. It checked wires for cam position sensors all look good, it goes into limp mode climbs a hill at 45 mph. Will not accelerate and keeps putting the traction control light on. Anyone with ideas!! All sensors reading good on the scanner

 

[moparmadness1973]

Have you had a cam-crank relearn done since replacing sensors.

All 4 sensors read. Notice it does it more the hotter the outside temp gets